Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bench bleed the brake master after junction block replacement? 200 1989

posted by  someone claiming to be Michael Yount on  Sun Sep 28 19:06 CST 2014 [RELATED]

And for anyone else who finds this on "search" -- a piece of tape over the vent hole on the master cylinder cap will keep the fluid from coming out when you open up the system elsewhere. If air can't get into the top of the reservoir through the vent, the fluid in the reservoir won't leave. Many, many repairs (replaced calipers, front brake lines, added SS braided lines, etc.) this way and the reservoir stays completely full. Simple matter to bleed the air out of the new line, caliper, etc.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bench bleed the brake master after junction block replacement? [200][1989]
posted by  Epic2112  on Tue Feb 18 16:55 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.