Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing breather box on 960 -- best method? 900

In my quest to keep the oil in our V90, I need to do this job (replace breather box) ASAP. I have read about two methods. FCP even has a nice video showing the replacment on an S70 where they pull the intake manifold. Lots of stuff to take apart, but the video doesn't make it look so bad.

Obviously the 960/S/V90 motor is in line, which changes the game slightly as you could get access from the front with the PS pump and alternator removed.

Do you pull the intake manifold? Just how hard is it?

Or is it easier to remove the alternator and go in from the front? If memory serves, Aye Roll (Rob B.) says they use this procedure in his shop.

Thanks!
Andy R.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Replacing breather box on 960 -- best method? 900

    its all about the same,you either fight under the intake and save time by not removing it or just go in from the top,if all the intake stuff is original you should go that way and put in new intake gaskets etc.
    enjoy







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.