Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2016 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Volvo 740 cruise control engine bay wiring location and pedal switch 700 1989

Hi all, I am attempting to add cruise to my 89 GL 740 5 speed. I have installed the computer, vacuum pump, bellows and intake components. I am stumped as to the location of the wiring harness for the vacuum pump in the engine bay. is there some wiring I am missing? Is it bundled up somewhere I can't see? In the cabin? Any thoughts would be much appreciated.

Also I have a 5 speed I am supposed to have 2 switches on the pedals to cancel cruise. I only have a mounting tab for one switch in the footwell above the brake pedal. Any idea why I only have one mounting tab for this switch? I also only have one wire to go to this switch. Supposedly there should be 2. thoughts?








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Volvo 740 cruise control engine bay wiring location and pedal switch 700 1989

Any chance your donor system is from a turbo? My turbo 760 had a vac pump but my '81 240 GL did not...just used engine vac.

The switch on the brake pedal should normally have two connectors if you have cruise...since yours does not, I think you can just splice the wire.

No clue on a clutch pedal switch as none of my cars with cruise had one.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.