Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2021 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Inexpensive cam seal press tool 900

uid 55's pic
posted by  john sargent on  Sat Dec 10 12:46 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

I just replaced the camshaft seal on one of our cars. I used an 1-1/4" die cast EMT (Electrical Metallic Tubing) connector to press the seal in place. The fitting goes over the camshaft, and fits inside the recess for the seal. I removed the two set screws and cut the set screw bosses off the connector. Using a longer bolt of and a large washer allowed me to nicely press the seal to the bottom of it recess. The electrical fitting cost $2.50 at a local hardware store.


--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 7 Inexpensive cam seal press tool [900]
posted by  john sargent subscriber  on Sat Dec 10 12:46 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.