Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

A bad or incorrectly tightened wheel bearing .... 200 1990

posted by  Ken C on  Mon Oct 24 22:09 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:39 CST 2014
[RELATED]

re: "...I replaced one rotor when I did the driver's side wheel bearing..."

A bad or incorrectly tightened wheel bearing will also cause this -- anything that will cause the rotor to wobble -- because it will push the pads away from the rotor surface as it spins. Are you sure the hub was tightened (and the bearings seated) properly? Or the "hat" of the rotor seated on the hub straight, without anything (piece of debris) beneath to make it cocked to one side?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Brake Booster or Master Cylinder ? [200][1990]
posted by  philvo subscriber  on Mon Oct 24 09:23 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.