Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Seat heater repair 900

uid 55's pic
posted by  john sargent on  Thu Oct 20 19:56 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

I just made a repair to the driver's side lower seat heater grid in my 940. The broke (burnt) spot in the wiring is quite obvious, you can't miss it. I pulled enough wire out from both sides of the break to pull the ends through the crimp sleeve I made from a stake on fitting. I cut the fork off of a stake on fitting like is shown in the picture, and pulled both ends of the wire through the sleeve I'd made, and crimped it very hard. It is sure a lot easier than soldering wire that as been hot, and pressure connections are much better for carrying amps than solder connections are.


--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Seat heater repair [900]
posted by  john sargent subscriber  on Thu Oct 20 19:56 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.