Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 8/2013 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

heater controls 200 1992

heater control switch does not change air flow .i put another fan motor in. can anyone tell me what to check in case i missed something when putting back together.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    heater controls 200 1992

    Calvin,

    I'll cut you some slack since this is your first post, welcome aboard! More information is needed when you post with a problem like this. It appears that you replaced the fan motor, but did you also replace or resistively test the fan resistor that is inside the blower housing? What method did you use, was it "chainsaw" or full dis assembly? Did you also test the fan speed switch? Is the fan running at all now? Did it run at all before fan motor replacement?

    Finally, did you keep track of the ground wiring connections to the bolts that go into the floor to mount the fan housing? That one bit me quite a while ago.

    More info upfront results in more accurate responses.

    jorrell
    --
    92 245 307K miles, IPD'd to the hilt, 06 XC70, 00 Eclipse custom Turbo setup...currently taking names and kicking reputations!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.