Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

FYI to those who replace rear trailer arm rear position bushings 200

posted by  trichard on  Sat May 21 15:23 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:52 CST 2014
[RELATED]

for those who do this job and have made the tool needed to remove and install these bushings the heavy washer used in back of the crank shaft bolt is the same (close enough) diameter as the outer diameter of the the rear bushing and can be used to easily push in or pull out this bushing.

obviously you're not going to remove the crank bolt to get the washer to use but if you troll junkyards and happen to pick up a spare balancer hold on to the washer.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 FYI to those who replace rear trailer arm rear position bushings [200]
posted by  trichard  on Sat May 21 15:23 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.