Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2016 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Alternator/Regulator Wiring 120-130

I am replacing an unknown Mfg Alternator and Ford Regulator with a Bosch Alternator and Regulator in my 1961 Amazon and need some help with the wiring. The Alternator has 4 posts B+, D+, D-, and DF. I have hooked the B+ up to the starter, where it meets the Battery +. The D+, D-, and DF are attached to the corresponding posts on the Regulator. Unfortunately I have a wire left over, which is orange in colour. It disappears into the wiring harness and I don't know where the other end is. I believe the "orphan end" was attached to the "A" post on the previous regulator. I don't know where it should be attached in the present configuration. Any ideas where it should be attached on this regulator? As there are no spare posts I assume it must "double up". Any ideas where the other end is?. Thanks in advance for your help and please bear with me, as I am a little "thick" on things electrical.
Bill






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Alternator/Regulator Wiring [120-130]
posted by  ecliffs  on Tue Apr 19 16:44 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.