Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2021 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1993 940 head gasket 900 1993

posted by  spook on  Thu Feb 3 21:46 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:06 CST 2014
[RELATED]

Dear MadDogKY,

Hope you're well. The metal coolant pipe - which runs from the back of the water pump, along the block, and then turns towards the driver's side of the engine bay - may have a pin-hole leak.

Unless the hose is greatly over-size (it should have a 5/8" internal diameter) you should be able to tighten the clamp enough, to prevent leaks. If, however, the hose has a 3/4" internal diameter, even a fully-tightened clamp may not suffice.

If, after you install the Volvo brand hoses, there's still a leak, the metal pipe needs to be inspected carefully.

Hope new, Volvo-brand hoses are the cure.

Yours faithfully,

Spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 940 head gasket [900][1993]
posted by  MadDogKY  on Wed Jan 26 12:54 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.