Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

What kind of putty to fill blower motor wire hole? 200

Well the blower motor is in and working. Now what do I use to seal the hole where the wires exit the blower box?

Mark








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

What kind of putty to fill blower motor wire hole? 200

Hey Mark,

I'm tempted to say "anything you have around," because that's how I approached it. I just happened to have this electrical supply type dum-dum putty -- pretty cheap if you look at Home Depot. Bubble gum would probably work too.



--
Art Benstein near Baltimore

"I usually take a two hour nap from one to four."








  REPLY TO THIS MESSAGE    PRINT   SAVE 

What kind of putty to fill blower motor wire hole? 200

The rubber grommet that should have been in place prior to your repair.

Was it not present?
--
'80 DL 2 door, '89 DL Wagon








  REPLY TO THIS MESSAGE    PRINT   SAVE 

What kind of putty to fill blower motor wire hole? 200

Unfortunately it broke.

Mark







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.