Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 oil seperator 200

posted by  TONY H on  Tue Jun 22 07:23 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

Just my 2 cents
I THINK the tube is to prevent splash back up into the Separator from the spinning Crank.
Without it might get the Separator dirty sooner but more importantly I would worry about Gasketting the Separator at that second hole. I wonder if a coat hanger with a hook bent in the end will be able to run down the center of the tube and hook the bottom. then wiggle it up and out.

The 'O' ring that you think is missing from the fist hole is surely stuck to the bottom of the separator disguised as part of the plastic separator.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.lyse.net/brox/TonyPage4.html






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 oil seperator [200]
posted by  soundman2033  on Tue Jun 22 01:03 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.