Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Why not use old shell for urethane bushings? 200 1982

posted by  nabramson on  Sun May 16 19:13 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 20 15:00 CST 2011
[RELATED]

I guess that this settles the matter !

Good Afternoon Neal
The bushings have been designed to have shell part removed
If the shells are not removed the sizing of the bushing will be incorrect.
The bushings will be too tight in the arm which will in turn potentially cause failure of the arm.
I hope I have answered your question
Regards
Darryl Jamieson
Technical Support R&D
Fulcrum Suspensions Pty Ltd
P: +61 7 3892 9000 (Ext 411)
F: +61 7 3892 1526
E:darrylj@fulcrumsuspensions.com.au
www.fulcrumsuspensions.com.au
www.superpropoly.com
www.tein.com.au






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Why not use old shell for urethane bushings? [200][1982]
posted by  nabramson subscriber  on Sat May 15 11:08 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.