Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2022 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

posted by  Xraybob on  Thu Jan 28 06:39 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I'm going to replace my front rotors and pads next week (78K miles). I was going to replace my rear pads also (same mileage). What should the rear thickness be before they need to be replaced? I know the fronts take most of the use and abuse.

Thanks for your thoughts and input.
--
'86 sedan with 430,000 miles on the original engine and automatic transmission








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

posted by  Xraybob on  Thu Jan 28 12:45 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I was looking to get the thickness for the rotor instead of the pads.

--
'86 sedan with 430,000 miles on the original engine and automatic transmission








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

posted by  BlueGoose on  Thu Jan 28 12:28 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Aug 17 15:25 CST 2010
[RELATED]

3mm. But the last time I replaced my rear pads they were about 5-6mm. They had been on there for many years and I just got tired of waiting for them to wear out.
--
1986 Volvo 245








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

posted by  244760 on  Thu Jan 28 11:36 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Feb 26 10:10 CST 2010
[RELATED]

New pads are about 10mm give or take,this is pad thickness,not the metal backing.If the rears are more than half,I usually replace them.


Dan








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor thickness 200 1986

posted by  ricko on  Thu Jan 28 11:25 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Aug 21 08:31 CST 2014
[RELATED]

IIRC half inch comes to mind.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.