Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

93 940t no heat, electronic servo question 900

posted by  david hunter on  Tue Dec 29 17:18 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 30 22:10 CST 2014
[RELATED]

I am not familiar with the 940 heat/AC control system but I do know a bit about the ECC system on the 960 series. Not sure what years had this but for sure the 97 did and most likely earlier years. The mixer servo is directly controlled by the electronic unit in the dash (ECC). The servo assembly on the 960 includes a pot for position feedback, I believe that whole assembly is connected by 5 wires.

There also is a temp sensor in the dome light assembly that uses vacume to draw a small flow of cabin air over the actual sensor, I have heard of the small air entry tube or hole getting clogged with dust. The signal is used by the ECC to regulate cabin heat by open/closing the mixer shutter as needed.

The 960 system has self diagnostics and fault codes which read from flashing of the AC OFF button light.

I do not know if the systems are similar, the same or vastly different.
--
David Hunter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 93 940t no heat, electronic servo question [900]
posted by  ohsotired  on Tue Dec 29 10:25 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.