Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Getting nuts off Exhaust manifold studs-any advice ? 200 1982

Incredibly enough, if you feel you might be about to shear a stud off, you might try tightening the nut. Sometimes this is just enough to break the bond in there, and then you can back things out. Good luck on this venture. Your PB Blaster bath or Kroil is a good thing to get things shaking loose.I would use a good quality 6 point socket for this job.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting nuts off Exhaust manifold studs-any advice ? [200][1982]
posted by  nabramson subscriber  on Fri Sep 18 06:22 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.