Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2010 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine mount replacement - how much lift needed 700 1990

posted by  spasske on  Mon Aug 31 14:22 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 10:11 CST 2014
[RELATED]

I'm planning on replacing the engine mounts on my 90 turbo wagon. I built an engine lift rig and I have enough thread to lift it 3 inches. Is that plenty of lift or should I look for another eyebolt?

I did this many years ago but no longer have the original rig. I recall that I was really close to not having enough lift to do the job.

IS this job best done with the car on ramps and lifting from above?
--
Paul NW Indiana '89 740 Turbo 140,000








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine mount replacement - how much lift needed 700 1990

posted by  VolvoSteel on  Mon Aug 31 14:52 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 23 21:28 CST 2014
[RELATED]

i found the simple way was to unbolt the bolt in the center on top them unbolt the entire assembly from the frame and all you need is about 1 inch of clearnce and it will slide right out.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.