Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2017 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Changing accesory bushings 200 1986

posted by  yrots on  Sat May 9 02:26 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 12 11:19 CST 2014
[RELATED]

With the search function temporarily out I need to ask my questions. Is it preferred or necessary to remove the P/S pump in order to replace the A/C accessory bushings? I can see the 2 lower are accessible from underneath but the 2 upper bushings appear to be much more inaccessible.

Dirk
--
Dirk Story








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Changing accesory bushings 200 1986

posted by  benski on  Sat May 9 11:44 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 12:07 CST 2014
[RELATED]

I pulled out the whole shooting match when I put in poly accessory bushings. It gave me an opportunity to clean things up and take a close look. Additionally, I took a little crocus cloth and cleaned out the holes for the bushings. Then, a little of the grease used in the kit for the sway bar on the bushing, and I used a pair of water pump pliers to press the new bushing in to place. Finally, another little slather of grease on the steel bushing, and once again used the pliers to press that piece in after the poly bushing was already in place. Hope this helps.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.