Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re-soldered ALL my relays yesterday... 900

uid 17648's pic
posted by  Shifted on  Fri Jun 1 11:10 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Nov 19 19:05 CST 2011
[RELATED]

The covers are just held on by plastic tabs hooked over the bottom boards. A couple of small screwdrivers used with care can be used to gently pry them back, then the covers will slide off. You have to pry and pull at the same time, being careful not to break the boards. Also don't ram the drivers too far into the case or you could mess up the internals of the relay.

When you are finished the covers will snap back on, careful again not to break the bottom boards.

Piece of cake, really. You could practice on a bad relay at first if you are worried about messing something up.

: )
--
Scott 'Bricking on Japan time' Night shift is ON
--------1993 945 GLT 74,000--------1973 Suzuki Jimny 'Brute' 61,000--------
A Deeper Love






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Re-soldered ALL my relays yesterday... [900]
posted by  Shifted  on Thu May 17 15:56 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.