Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1 2 3 code ECT and grounds 200

I am backprobing @ #13 with ecu still connected and a good ground w/black lead, operating temperature with key in run position.

No sealants used in ect sensor install

My question was would impedance at block ground basically render the ect sensor inoperable thus giving me a voltage reading with minimal resistance?

Or if the block ground I'd bad (side of block), will the voltage be zero @ 13 with same circumstances as above.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 2 3 code ECT and grounds [200]
posted by  SBPal  on Wed Jan 16 10:35 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.