Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

problem with wiring to fuel sensor 200 1992

uid 2796's pic
posted by  bulletproof on  Wed Nov 30 02:55 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:02 CST 2014
[RELATED]

Sounds like a great solution. I never though about epoxy as a seal. Fortunately, when my wagon had this problem, I had a good used sending unit on hand. But this would have been a lot easier because I had to change the early prepump for the later.
Sometime when I have some time to kill I'll repair the original unit as you have outlined. It's still usable.
--
'80 DL 2 door, '89 DL Wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New problem with wiring to fuel sensor [200][1992]
posted by  someone claiming to be Richard O'  on Tue Nov 29 23:52 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.