Volvo OPINIONS Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2025

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

2001 S-60 TCM

posted by  downtime12 on  Fri May 24 08:39 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My 2001 S-60 recently went into "limp mode". I am checking a few things, but had a question about the TCM. If it turns out that this is the bad part, can I just replace it with a used or new one? Or does the "new" TCM have to be reprogrammed to match my vehicle? I have not contacted a Volvo dealer to ask them this yet. I figured I'd ask here first.
Also, do I have to take the ECM out first in order to get the TCM out, or can I use the special tool (which I borrowed from a friend) to just take the TCM out with leaving the ECM untouched.
Initially thoughts are that the issue is either the TCM and/or the input and output speed sensors and/or the wiring of this based on tests done with scan tools with Volvo software. I am going to pull the TCM out and test the board first, then go from there...
Thanks in advance!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2001 S-60 TCM
posted by  downtime12  on Fri May 24 08:39 CST 2019 >
  • New 2001 S-60 TCM
    posted by  Bill Bretherton  on Fri Jun 7 01:30 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.