Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2007 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Upper torque bushing. 850 1996

posted by  the kick inside on  Sun Apr 4 12:41 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 17 09:58 CST 2007
[RELATED]

gear puller (about $15) , a large washer that will sit in the bushing, but not over the metal rim...a socket & driver...just wind the sucker out!..takes about 5 mins and two sets of hands (preferably) - one set to hold the puller in place...one to wind...also can be used to pop back in (but more difficult)..for back in two circles of wood 3/4 thick and holes through them off set to match the bushing, 10mm rod bolt down the midle, two large washers on the outside of each piece of wood and two nuts ... wind the sucker in...

i found some grease helped on the back in...

buy a gear puller that can be 2 arm or 3 arm (sort of like a construction set)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Upper torque bushing. [850][1996]
posted by  JimH subscriber  on Sun Apr 4 03:37 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.