Volvo AWD S70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2007 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tune up questions S70

posted by  Mad Finn on  Sun Oct 27 16:34 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Soon I'm going to toss new plugs, rotor & cap in my 98 S70 GLT. On past cars I've had, the rotor just slipped on a shaft, end of installation.

According to my maintenance manual, on this volvo there are 3 screws that hold the rotor on, and it mentions making a mark so when you put the new rotor on, you can align it to the same position the old one was at. How critical is this?

Also, taking the cap off looks to be a pain with everything else around it, especially reaching the bottom screw that holds it on. Any tips on getting it off?

And regarding the flame trap, my manual implies that only the non-turbos have a flame trap, is that the case? If so, does the turbo have anything similar or a PVC valve I have to check/replace?


Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tune up questions [S70]
posted by  Mad Finn  on Sun Oct 27 16:34 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.