Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2012 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Let's break this down... 850

The car ran OK before the work, right? After reassembly, the car runs rough, right? Lots of parts had to be removed/disconnected in order to install the rear main seal and replace the oil pan (perhaps the engine was pulled? sub-frame dropped?) BTW, I hope they replaced the O ring on the oil pick-up tube while they had the pan off...

I'm going out on a limb here, but I'll go with the assumtion that something was just not hooked back up right. Also, the mechanic who spoke of the computer needing to "re-learn" how to idle properly is mis-informed. Too bad you had to buy an idle control motor for nothing.

Good Luck
--
RussB in Ct. - '96 855T- '91 940T - '93 850GLT (R.I.P. 6-16-02)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help!!! [850]
posted by  Dr D  on Fri Aug 30 05:11 CST 2002 >
  • New Help!!! [850]
    posted by  someone claiming to be brickme  on Fri Aug 30 06:54 CST 2002 >
  • New Help!!! [850]
    posted by  someone claiming to be Ray N.  on Fri Aug 30 07:01 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.