Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to install IPD's engine mount? 850

posted by  danielflading on  Thu Jun 27 03:54 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I installed the IPD "Type" mount (identicle poly kit) from an independant parts shop and it was only 22.00. (VPI 713-722-0505)

about 10.00 less than IPD wants for the same thing?????

use a hacksaw to remove the old bushing, put the hacksaw blade through the old rubber mount, reattach the saw handle to the blade and then cut throught the old mount but not into the mount bracket. the old mount should come right out then.

Take the new mount with the arrow facing the firewall and install the two pieces, insert the roller into the bushing.

install the bolt and nut, you be done!

no neeg to jack up or support anything. should take about 10 minutes.

Dan

I can also email you an installation sheet if needed.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to install IPD's engine mount? [850]
posted by  genie  on Wed Jun 26 10:33 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.