Volvo AWD S40-V40 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2001 S40-V40 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

replacing front hub S40-V40 2007

posted by  riverbend on  Mon Jan 27 20:21 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:29 CST 2014
[RELATED]

Hi Klaus,
I think that it is similar but not sure if it the same. I tried O'Reilly's and they had a useable puller once I ground the heads off the studs and knocked 3 of them out of the way. The puller looked substantial but I had to straighten it with a press. NAPA doesn't have anything even close. I stopped at Absolute in Delano and Chad said that they had sent someone with a similar issue to Borton. I called Borton and the service writer said he would have to check with the techs to see if they had the tooling to press the hub into the knuckle! The techs won't be in until 7:30 tomorrow morning...

Freezing the bearing and heating the knuckle could give me a few thousandths. I have a couple meetings in Minneapolis tomorrow and I'm thinking I'll stop by Discount Steel and see what they have for 5/16" cold rolled plate.

Greg





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacing front hub [S40-V40][2007]
posted by  riverbend subscriber  on Sun Jan 26 18:58 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.