Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2001 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

took apart new door stop piece...how to reassemble? 850

posted by  andysumms on  Sun May 25 11:11 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 5 20:05 CST 2014
[RELATED]

Klaus -

Thanks for responding - it took a while but I got the two pieces of door stop together - the green "carabiner" into position and the flat piece between the rollers. I torqued on it in a vice and bent the carabiner part a bit but it installed just fine.

The disappointment came testing the door - it stops but barely now at the stop points - a wind or just momentum will close it - its not like the other doors.

What did i do wrong? I put grease on the rollers and the bar - too much? Would bending the vertical rod of the green part change the resistance at all?

I installed genuine volvo from FCP.

Thanks for any insight,

Andrew / St Paul, MN






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New took apart new door stop piece...how to reassemble? [850]
posted by  andysumms  on Sat May 3 19:15 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.