Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

testing 850 maf sensor 850

posted by  tmannian on  Mon Nov 29 03:18 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 20 10:31 CST 2014
[RELATED]

Ignition on (but engine not) .1-.2 V.. Idling should be about .9V. Should go up as speed goes up...

To check, first make sure the intake air hoses are not cracked.. Then engine off/key in ignition check pin 3 vs the ground. It should be battery voltage. If not theres your problem. Pin three is the 2nd from the left when looking at the pins (ie, you're the MAF and the wires are going into you.. 2nd from left). If OK then turn the car off, and wait 5 minutes, then check pin 4 (far left same viewpoint) for resistance. It should have 9-11K Ohms, if other report back. If OK ignition on (engine off, MAF connected) again, and check voltage between pins 2 and 4. Should be .1-.2V if OK, start car, check at idle should be ~.9V.. If it all passes then wiring and MAF are good.

--
If you're not driving it "like its stolen," are you really driving?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New testing 850 maf sensor [850]
posted by  mintchaser  on Sun Nov 28 09:14 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.