If you would like more detail on one of these let me know.

-Jeff

DTC 2-3-2 Long Term Fuel Trim, Idling

2-3-2 LONG TERM FUEL TRIM IDLING

Precondition for DTC

The control module receives information from the Heated Oxygen Sensor (HO2S ) about the fuel/air mixture in the idling and partial load ranges. If the fuel/air mixture deviates from Lambda=1 the short term fuel trim will compensate this by adjusting the injection timing so that Lambda=1 is achieved. When the short term fuel trim carries out this adjustment, its mid-point must be adapted by the long term trim. When the long term fuel trim has adapted the short term trim to a maximum value, DTC 2-3-2 (idling range -0.48 ms to +0.40 ms) or DTC 2-3-1 (partial load range 0.773 to 1.227) and status message Upper Limit (lean fuel/air mixture) or Lower Limit (rich fuel/air mixture) will be set.

Substitute values

None.

Fault sources

Upper limit:

Defective Mass Air Flow (MAF ) sensor.

Low fuel pressure.

Air leakage.

Faulty sensor signals.

Lower limit:

Defective Mass Air Flow (MAF ) sensor.

Air leakage.

High fuel pressure.

Leaking injectors.

Leaking EVAP system.

Dirty engine oil.

Oil level too high.

Faulty sensor signals.

Fault symptoms

Can result in high fuel consumption.

Can result in impaired performance.

Copyright © 2000 ALLDATA LLC.