Volvo AWD S70 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2019 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Setting CD Changer angle as part of installing. S70 1998

posted by  sulloway on  Fri Jun 26 14:21 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri May 6 06:12 CST 2011
[RELATED]

My Cd Changer install project has gone OK. Before I bolt it up in place, I noticed a small plate on one side that had a series of holes in the side going from 0 to 90 degrees. I dimly remember something about adjusting the angle of install depending if the deck was installed facing up or out or at some angle in between.

There is also a single screw holding the plate with all the hose into the case.

How do I set this?

Regards

Woody






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Setting CD Changer angle as part of installing. [S70][1998]
posted by  sulloway  on Fri Jun 26 14:21 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.