Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2003 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pin out for oxygen sensor 850 1996

I am replacing my front oxygen sensor on my B5252FS engine. The existing sensor has four wires, red, white, yellow and black. The sensor is a NTK A4R, The replacement is a generic bosch. Can anyone identify, which two wires are the heater, which is the signal and which is the ground. I have tried netering the sensor, but ALL wires are open? I cannot meter out the connector on the car as it is not in my driveway. Any help would be greatly appreciated. I ahte it when a simple task turs into a days project!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pin out for oxygen sensor [850][1996]
posted by  cdnmike  on Sat Jul 14 21:31 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.