Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2007 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

torque arm bushing installation 850 1993

posted by  the kick inside on  Mon Apr 3 11:04 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu May 17 09:58 CST 2007
[RELATED]

i have also done it this way with no issue, but i did have to reduce the bushing by a fraction using sandpaper to get it to go at all! Scuttlebut has it theere are two sizes that are fractionally differnt (v70 perhaps beign different) I would believe this because i think i had a couple of tons of presure on it and it wouldnt go...a fraction sanded off and it went in pretty easy....well considerting i had a 10 mm bolt running through it and leaning on the nuts to draw it in!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New torque arm bushing installation [850][1993]
posted by  someone claiming to be Jeremy  on Fri Mar 31 05:36 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.