Volvo AWD S60 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 S60 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine splash shield and angle gear S60 2002

posted by  someone claiming to be Bob on  Wed Feb 15 12:38 CST 2006 [RELATED]

Splash shield is standard on all auto trans and I think manual Turbos. It was not fitted to the normally aspirated manual trans cars. Bevel gear seepage is very ccommon from either the shaft seal or the O-ring on the side gear crown wheel retainer. Less common is the pinion seal under the flang for the drive shaft to the rear. If you do install the splash shield, the seepage if it begins to get worse, will collect in the splash shield before it hits the ground.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine splash shield and angle gear [S60][2002]
posted by  someone claiming to be Davis  on Fri Feb 10 13:15 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.