The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Vibration problem S40-V40

Hi Sven,

my 97 S40 2.0l has 210'000km. Since a long time I have a noise problem around 3000rpm (noise is increasing). My upper engine mounts also show no sign of obvious wear but sometimes even without a cracked appearance they may be worn. I have ordered left and right engine mounts and will receive them next week (these are those fitted on model 2000).
Will tell you if it improve anything

But did you check the torque settings of the through bolt of the 4 engine mounts? A loose bolt may cause excessive vibration and sometimes one that is too much tightened too. It would be a good thing to remove the engie mounts completely to inspect them. My front and rear engine mounts were shot one month ago and the engine was vibrating a lot when releasing the clutch pedal. I looked at them and they seemed OK. However after removal I could see little cracks in the rubber. Now those lower engine mounts are new and I have no more shacking of the engine.

Regards

kilou






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.