1995 850 turbo auto OK, started the PNP replacement tonight with the intention of stopping and asking questions if I had any before I completed the job tomorrow. Everything is going well following the bay 13 instructions with the exception of getting the the old PNP connector out of the holder. I followed all of the instructions including using WD40 and breaking off the clips referenced. In Rich's instructions he says:

"... you need a small screwdriver or pick to stick down in the connector where I have the blue line drawn (where's the line???) to push the blue connector inside the switch towards the front of the car just enough so that it releases and allows you to pull the inside of the switch up and out of the holder".

For the life of me, I cannot find the blue line he refers to in the photos; there are what appears to be blue connectors up and down the holder. Do place the pick all the way in the back of the holder or do I place it at the point where I noticed the new connector has the blue tab - a little after the third row of pins facing toward the rear of the car?

Thanks!!!!!