Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Highlights Position Sensor Level V70-XC70 2005

Hi all,

I have an XC70 AWD '05 without Four-C and I need to replace the sensor level (P/N 8622446).

The sensor was easy to remove, just one nut, however, I forgot to take a picture and I could not figure out where the bracket would go.

http://www.mediafire.com/view/4jel1x8yqwr1ev4/IMG_20190505_103441.jpg

This was until few minutes ago when I realized that the bracket should be connected to the body of the suspension with a rivet.

In fact, the rivet in the bracket is broken and my question is how to access that hole with the broken rivet in it.
It is not possible to reach a workable position from under the car so the only possibility I can see is to remove the wheel, but I think I will need to remove the disc too.

I still cannot understand how it is possible that they did connect that bracket to the suspension using a rivet which with the time has been eaten by corrosion.

Anyhow, that point is very difficult to reach, assuming I can manage to do it, should I go for a screw rather than a rivet?

As anybody ever had this issue?

Thank you,
Alex






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Highlights Position Sensor Level [V70-XC70][2005]
posted by  Metallo  on Thu Jun 13 20:11 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.