Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2002 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

bump stop clip 850

The bump stop is bouncing around in the rear spring. I bought a new bump stop clip but am a little mystified how it's installed. I tried pushing it through the hole in the top, but it's too short to actually clip into the upper piece. It also looks different than the other clip feels. I searched the archives and it was mentioned that Rich provided install instructions, but I couldn't find it. Suggestions, please?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    bump stop clip 850

    I just replaced one of these clips on my 96 850R. It was a PITA :-) I first pushed the clip inside the bumstop and up through the hole in the top. Once the top of the clip was visible through the hole I held the bumpstop up using a 1/2" drive extension (it fits inside the bumpstop and allows you to put upward pressure on the clip). I used a large, flathead screwdriver and a little leverage (using the spring) and the clip snapped into place. Doing this while laying on my back and reaching inbetween the spring coils was interesting (I of course jacked that side of the car up to extend the spring).

    Good luck!

    -Brad.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.