Volvo AWD S80 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2005 S80 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing rear bumper cover? S80 2000

How complicated is replacing the rear bumper cover on a S80? A brief outline of the procedure would be appreciated before I decide if I should tackle it or take it to a shop. I would buy it prepainted. Thanks Larry








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing rear bumper cover? S80 2000

Easy job. Jack up rear, remove wheels - drill out rivets holding bumper panel to wheel arch. From inside boot, one nut each 'corner' of boot (remove trim panel) - one side you'll need to unplug aerial lead. Centre of inside - remove rubber covers, using extension on socket spanner under two more nuts. Whole bumper assembly pulls back. Its not too heavey, but carefull how you put it down. Take opportunity(which is why I took mine off) to install reverse sensors.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing rear bumper cover? S80 2000

Paul, Thanks for the encouragement and information. Larry







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.