Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2001 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear spring 850 1997

The rubber stop inside the rear coil spring pulled apart from the top mount.
so it's sitting at the bottom of the coil. Both pieces look in good shape .
Before I tear it down . Is there a bolt to fasten it back together or should I get a new one. Thanks.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear spring 850 1997

The bump stops are held in place with plastic push pins. List price for them is $0.86, the thieves at Rick Hendrick Superior Volvo of course charge $1.20 each for them.

A good writeup on changing them out is here:

http://volvospeed.com/Repair/SpringBumpStop.php

The retainers that I purchased had the pin molded into the retainer and I had to break it off. It also fit very, very tight so I wound up reaming out the hole in the retainer so that it would lock the retainer in place with a reasonable amount of force. I used the spring itself as a fulcrum and levered the pin in place rather than trying to tap it in.

...Lee







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.