Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2010 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

pressurewashed my engine....and now the boost gauge doesnt work...?? 850

i pressurewashed me 855R's engine to try to find the source of an oil leak...and now my factory boost gauge doesnt work... anyone have any ideas?
where do the vac lines run?








  REPLY TO THIS MESSAGE    PRINT   SAVE 

pressurewashed my engine....and now the boost gauge doesnt work...?? 850

It should run from the intake manifold, to the front core support, over the top of the fresh air intake for the air box, along side the left front fender,and then through the firewall and into the passenger compartment. Right about where it goes over the air intake duct there is a short piece of rubber hose that butt connects the plastic pipe, see if you have not knocked it apart right there. Otherwise check it out where it connects to the manifold itself, I think it is right there at the vacuum tree by the throttle valve end of the intake manifold.

Mark








  REPLY TO THIS MESSAGE    PRINT   SAVE 

pressurewashed my engine....and now the boost gauge doesnt work...?? 850

thanks.. the boost gauge is run by that yellowish white hard plastic vacuum line...i discovered i blew the line off the rubber tee by the battery.. i popped it back on and viola! easy fix :<)
thanks
guys







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.