Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How hard is it to replace an O2 sensor? 200 1980

Yer gonna need a 22mm wrench soon.... If you have not had that out in a time , the device will be stuck pretty good.... Take care what you put on it, as silicon will kill it....

Was the car hooked up to a Co tester, or when it ran bad, did you guess it was leaning out? It very well may have gone into rich mode, and ran just as poorly.... Mac






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How hard is it to replace an O2 sensor? [200][1980]
posted by  Dylan Berichon  on Fri Oct 31 20:27 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.