Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2022 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Coolant drain petcock 200 1989

I plan on replacing the radiator this weekend.

I never used the coolant drain (petcock?) before.
I understand it's on exhaust side, by #4 cylinder. Fine.

Any problems with these? I'd hate to have it break off or not seal properly when closing up again.

I can always drain via the radiator/pump lower hose instead, but that's messy and it will probably lose lots of pretty new coolant that way.

So I'd rather use the petcock if you folks can give me a clean go-ahead on it.

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Coolant drain petcock [200][1989]
posted by  Sven's Maintainer  on Wed Jun 29 09:22 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.