Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2016

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Factory tool kit on wagon - tip to keep in place

posted by  NJC on  Tue Jun 28 18:18 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jul 24 13:42 CST 2011
[RELATED]

I had actually removed this tool kit as it kept falling out/over. This is the tool kit fastened to right rear cargo panel.

Anyhow I was close to ripping out panels to try and get to the back side of the cargo panel as I had assumed the square plastic opening holding the plastic anchor screw had broken off.

Turns out it wasn't broken.

To fix I put a ~1/8" chunk of plastic on the bottom lip where the tool kit sits. This pushes the whole assy up enough so the plastic anchor will grab the top side of the square opening.

So now it's tight and I'm certain even getting all 4 wheels off of the ground wouldn't cause the dang thing to fall out now!
--
Norm Cook; Vancouver BC; 1989 745T 208,000KM






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Factory tool kit on wagon - tip to keep in place
posted by  NJC  on Tue Jun 28 18:18 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.