Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

PV 444 Gauge & Turn Signal Mechanism Cleaning

posted by  Belinda on  Tue Jun 28 16:33 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 24 08:25 CST 2013
[RELATED]

I know this is probably not the standard 6V to 12V fix, but I added a 90 ohm resistor behind my fuel gauge. I still haven't tested it yet, so I don't know if it works. Pic is posted here:
Resistor added to L gauge

Also found that the turn signal mechanism can be easily removed; the corroded contacts gently sanded with fine paper to get them clean, the whole mechanism cleaned with an aerosol cleaner (don't use carb cleaner as it will melt the resin in the composite), air dried or sprayed out with computer keyboard or electronics aerosol, and relubricated with a good dielectric grease:
Turn signal mechanism

The mechanism moves much smoother now.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.