Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Testing vacuum advance--how? 200 1988

posted by  mike chase on  Wed Jun 15 09:00 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 12 05:48 CST 2010
[RELATED]


I susupect that the vacuum advnace is now working properly (based on acceleration).

The tube running from the intake manifold under the engine down to the ignition module is OK (no leaks). At idle I have 8 in Hg vacuum. This goes down to 0 when you push the gas peddle down (which is as it should be). Pushing the gas peddle down results in slow increase in car speed (smooth but slow in comparison to my '90 240). The car is just fine at maintaining speed and getting up to speed isn't that much of a problem, there is not the kind of responsiveness that I get with my '90 240.

How do I test to see if the vacuum advance is working? It it is not a vacuum problem what else should I be checking into?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Testing vacuum advance--how? [200][1988]
posted by  mike chase subscriber  on Wed Jun 15 09:00 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.