Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2020

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

960 6304 intake manifold removal

posted by  jaydee on  Sat Jun 11 12:26 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 23:45 CST 2014
[RELATED]

I am in the process of removing the head from our 92 960 6304F engine, for overhaul, and am unable to pull the intake manifold aaway.
I have followed the Volvo service book to the letter, and am at the stage where I have removed the clamps holding the rubber intake hoses between head and manifold. According to the writings of Uncle Olof, the manifold should now pull away. It won't. Its tighter than tight. Won't even jiggle a bit. Like its bolted rigidly in place. I have tried a bit of prying with an oak stave, but don't want to get too carried away in case I have missed something, and wind up busting it.
Anyone ever have this problem? What am I missing?
JD
Fort St. John BC
65 1800S
74 Jensen Healey (sold tomorrow!!!!)
84 240GLE
86 740T
89 760GLE
92 960GLE (sick)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 6304 intake manifold removal
posted by  jaydee subscriber  on Sat Jun 11 12:26 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.