Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

mounting poly, front trailing arm bushings - v brace is in the way, what do I do? 200 1986

uid 17010's pic
posted by  tvg on  Wed May 18 09:50 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 21 14:10 CST 2007
[RELATED]

I know I've seen mention of this on the board - I started to hacksaw/chisel this feature off, but thought I'd take a break and see what advice others have. This v brace is on the inboard side of the outboard mouting bracket for the front of the trailing arm. It doesn't interfere with the OE rubber bushings but does get in the way of the poly bushing which has a lip outside the shell.
BTW, I used the burn/hacksaw/chisel technique to remove the original bushings which were beginning to crack and look worn. I will have all poly on the rear now (soon), except for the panhard rod.

Thanks for the help,
Tom
'86 245DL 238k





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New mounting poly, front trailing arm bushings - v brace is in the way, what do I do? [200][1986]
posted by  tvg  on Wed May 18 09:50 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.