Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2009 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

91,940 Turbo cam seal 900

posted by  jotvolvo on  Sat Apr 30 03:50 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 12 08:43 CST 2009
[RELATED]

Hi everyone,
Camshaft seal was leaking. To open the cam pulley, I ordered a tool from FCP Groton that I heard is same for Crank shaft and other two pulleys. But it does not hold the cam pulley (may be I don't know how to use it). So I hold the crank shaft pulley with this tool and slowly opened the cam pulley with care not to disturb the marks. Replaced the seal by opening the valve cover. I have no toruque wrench that has setting of 14psf but mine is craftsman's that starts from 20. Now I have two problems:
1. No torque wrench that can be used to tight the bearing cap and valve cover nuts as the torque is 14 psf. Where I can get good one?
2. Upon tightning the bolt for the cam pulley I used the same method as to open it. But the timing belt skipped on the center shaft and crank shaft and not the cam shaft pulley's. Now the timing marks for the cam has changed. Any suggestions to correct this scenerio would be appreciated.
Thanks
Ram






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 91,940 Turbo cam seal [900]
posted by  jotvolvo  on Sat Apr 30 03:50 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.