Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2012 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Thanks to the board! - Caliper Pin Question? 700

posted by  GOLDBRICK on  Sun Apr 10 13:21 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

90 760 T Sedan 212,000 miles

Replaced my front rotors, all four sets of pads and the second NIVOMAT (replaced the first one - that had failed - a few months back) on Friday....did the whole job in under three hours (with no impact wrench).

Just wanted to thank Steve Ringlee (7XX/9XX Maintenance Hints) and all the Volvo faithful on this board as reading about the various projects over the past year or so made the job(s) a snap.

One question for you "experts" What is the spec diameter for the caliper pins? I mic's mine at ~9.754 mm (.384") They feel noticeably loose in the caliper slides. I have always heard them rattling at low speeds. I know this is an abstract question/ Thanks in advance!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thanks to the board! - Caliper Pin Question? [700]
posted by  GOLDBRICK  on Sun Apr 10 13:21 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.